How Does An External Regulator Help My Boat’s Alternator Charge My Batteries?



This is one of our favourite products of all time. Most alternators have an internal regulator that limits the output. By adding an external regulator you will take care of the health of your batteries while charging faster.

admin

Solar panel battery charge regulators controllers CMG



I’ve tried out a new CMG solar panel battery charge regulator. This is the PWM type rather than the older switch on and off type.

admin

#DIY(Review) DIY 5V 2A Solar Panel Power Bank USB Charge Voltage Controller Regulator Module 6V-20V



I wanted to see how good this module was, I am using a 5V Solar Panel rated at 2.5W which is 500mAh. Not sure how accurate that spec is but will find out in this video.

So the goal is to make a effective Solar Charger not just something for show.

5v 2A Solar Panel Power Bank USB Charge Voltage Controller Regulator 6V-20V

https://www.ebay.com/itm/5v-2A-Solar-Panel-Power-Bank-USB-Charge-Voltage-Controller-Regulator-6V-20V-/112729886478?hash=item1a3f398f0e

Song: Joakim Karud – Waves (Vlog No Copyright Music)
Music provided by Vlog No Copyright Music.
Video Link: https://youtu.be/VMghJ_civuM

admin

Redarc BCDC1240 Install Video | Dual Battery Charger | Solar Regulator



How to install a Redarc BCDC1240 charger

admin

DATAKOM SMPS-1210 (12V/10A) Generator Start Battery Charges with Display



DATAKOM SMPS series are fixed output voltage, current limited lead acid battery chargers specially designed for permanent connection to genset starter batteries.
They maintain the batteries fully charged, without overcharging or gassing. Thanks to their continuous DC outputs they may also be used in a vide range of industrial applications where DC power is required.
When the battery voltage is below the float charge level, the charger provides constant current, nearly equal to the rated output current allowing a rapid recovery of the missing charge. When the battery voltage reaches the float level, the charger switches to constant voltage charge mode and maintains the battery fully charged, providing the maximum battery life.
The unit has overload and short circuit protections. They do not need disconnection during cranking. The high temperature protection of the unit reduces the output current in case of overheating.
The chargers are able to operate in parallel with the engine’s charge alternator and other battery chargers. Multiple units may be connected in parallel in order to obtain higher current ratings.
The wide input voltage range allows the chargers to be used in most countries.

———————————————————————————————
Web: https://www.controllers4generators.com
Facebook: https://www.facebook.com/controllers4generators
———————————————————————————————
For all questions and suggestions:
info@controllers4generators.com

admin

DATAKOM SMPS-242 DIN Rail mounted Generator start battery charger / stabilized power supply (24V/2A)



DATAKOM SMPS series are DIN Rail mounted, fixed output voltage, current limited lead acid battery chargers specially designed for use in gensets. Thanks to their continuous DC outputs they may also be used in a vide range of industrial applications where DC power is required.
The chargers are designed for permanent connection to genset starter batteries. When the battery voltage is below the float charge level, the charger provides constant current, nearly equal to the rated output current allowing a rapid recovery of the missing charge. When the battery voltage reaches the float level, the charger switches to constant voltage charge mode and maintains the battery fully charged, providing the maximum battery life, without overcharging or gassing.
The unit has overload and short circuit protections. This feature makes the units deliver only the rated current during engine cranking or a short circuit condition. They do not need disconnection during cranking. The high temperature protection of the unit reduces the output current in case of overheating. Thanks to their high efficiency, the self-heating of the chargers is kept in minimum levels allowing operation in warm environments.
The wide input voltage range allows the chargers to be used in most countries.
Charger metal case is neutral isolated thus it could be powered whether by phase-neutral or phase-phase AC voltage.

———————————————————————————————
Web: https://www.controllers4generators.com
Facebook: https://www.facebook.com/controllers4generators
———————————————————————————————
For all questions and suggestions:
info@controllers4generators.com

admin

How to Turn an Old UPS into an Alkaline Battery Charger!



What is inside an uninterruptible power supply? A lot of useful components! I show you a teardown of a UPS and uses some of the components inside to build a battery charger that will work with most types of batteries.
Webpage: http://www.afrotechmods.com

admin

Old Lucas Mechanical Voltage Regulator – For Old Tractor Dynamo Battery Charging



I found this with a bunch of old tractor bits in my grandmas woods when I was hunting! It looked like a 4 cylinder diesel tractor. This would have regulated the voltage coming from the dynamo. This tractor was probably made before 1960 because around the 1960’s they stopped using dynamos in cars and started using alternators. So this regulator is at least 50 years old.

Thank you for watching!

admin

How to wire and install a 20W Solar Battery Charger and charge controller



An easy-to-follow guide to wiring and installing a solar panel to charge a battery

admin

Scooter Charging System Check : Is It Working?



An easy way to verify that your scooter’s charging system is functional if you’ve been having trouble with the battery being low. Also check out my battery check video to see if your battery is working properly :

Thanks for watching.

admin